24v LED Driver 4794446

24v LED Driver 4794446

This type of converter is an exclusively designed stabilized power supply for LED lamp. With constant current constant voltage (CCCV) technology, it is suitable for constant voltage lamps (24Vdc) connected in parallel or constant current lamp (350mA) connected in series.
As an advantage of
CCCV technology, a switch can be installed between secondary side and lamps (when used as constant voltage regulator).

Built-in protection circuit will shut down the converter in case of Open circuit, short circuit, over load or over temperature.
The converter will restart automatically after failure removal.

Important information for the installation
The unit uses dangerous mains voltage (220~240V), it should be installed by qualified electricians only according to European safety standard or relevant nation regulations.
Failure to observe any of the installation instruction may cause fire or other hazards.

The converter only be used for LED lamp only, pay attention to the polarity of LED, wrong polarity may damage LED.

• The converter is only for indoor use and permissible operating

• Temperature is -20 to + 50°C. With terminal cover and cable clamp, the converter can be independent installed.

• The indicated load should not be exceeded. For 24VDC LED lamp, max 300mA or 7.2W. For 1W (350mA) high power LED, 1~6PCS.

Spec:

Rated input voltage (±10%):
220-240 Vac
Max power: 7.2 W
Frequency:
50/60 Hz
Rated input current (@ Pout max):
65 mA
Power factor:
0,6
Output rated current (±10%): 350 mA
Output ripple LF:
10%
Output voltage:
3 – 8.5 V
Max output voltage: 24 V
Number of LEDs:
1 ÷ 6
Ambient temperature (Ta):
50 °C
Max temperature at Tc point:
85 °C
Thermal protection:
yes
Overload protection:
yes
Short circuit protection:
automatic restart
Surge protection (L-N):
1 kV
Protection index IP:
20
Input cable cross section:
0,5-1 mm²
Output cable cross section:
0,5-1 mm²
Fixing/Connection:
screws diam. 3 mm (2x)
Dimension:
42,5 x 41 x 21 mm
Markings: CE, UKCA, SELV